|Home » |
Minn Kota Trolling Motor Power Center
The trolling motor power center is ideal for small boats without a battery compartment. It has easy to access external battery terminals that allow trolling motor leads and charger leads to be connected without opening the box. Built-in battery meter displays current "state of charge"' It also features 2 manual reset circuit breakers: 15 amp for accessory plugs and 60 amp for trolling motor.
Battery Holder/Case ONLY. Battery NOT INCLUDED.
Motor center ideal for small-boat transom applications
Easy-access batter terminals for connecting leads
Built-in battery meter displays current "state of charge"
Designed to fit group 24- and 27-size batteries
Offers pair of 12-volt accessory plugs and manual reset circuit breakers
|Average Customer Rating:
|| based on 620 reviews|
Average Customer Review:
( 620 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
230 of 238 found the following review helpful:
Trolling Motor Power CenterAug 22, 2009
By D. Dahlke
I'm very pleased with this box. It's not weak or flimsy and has molded in lift handles on each end. Its inside dimensions are 13"L X 7"W X 9"H. The vented cover has access for cables on either end and has a pretty sturdy handle attached that will tip down and lay flat and includes a steel backing plate inside for reinforcement and strength. Inside the cover is a plastic plate covering the internal wiring but can be easily accessed by removing two small screws in the cover. Underneath is the trolling motor terminal wiring, the circuit breakers, and the 12 AWG wiring for the accessory terminals. On top of the cover the battery charge indicator light illuminates when you press the test button. Instructions are also printed on the cover. The 10 AMP circuit breaker is wired to both cigarette lighter style accessory terminals, one on each end, and the 60 AMP circuit breaker is wired for the trolling motor accessory terminals. Also includes a nice sturdy belt to hold the cover on with and easy to use connector, not a buckle, and a pair of plastic hold down brackets if you need them. This box is very well thought out and built for its intended purpose. I can't think of anything else I'd want from it.
74 of 75 found the following review helpful:
Great battery holder for boats without built in battery trayNov 19, 2009
By V. Menides
Purchased this battery holder for my 14' Jon boat. I have a 55 MinnKota trolling motor and a fish finder which hook up easily with this holder. You get every thing you need with 2 circuit breakers one for your trolling motor and one for accessories that plug into the 2 cigarette lighter plugs. I had to make a power cable for my portable fish finder, so it could be plugged in. Test button on top tells you how much charge you have left in your battery. Sturdy case that makes it easier to carry a 50lb deep cycle battery.
I highly reccomend for any need where you are using a heavy duty battery that you will be moving from place to place. I will also be using this to power my 3000lb utility winch. For 110 volt power I hook up my inverter to this power center.
69 of 71 found the following review helpful:
Very usefulOct 21, 2011
By Amazon Customer
I use this to store a spare auto battery in my car's trunk. FYI - there are two circuit breakers, one 10 amp for the two cigarette lighter sockets and one 60 amp for the screw terminals. There's also a voltage monitor - press the yellow "test" button and you get a 4 LED readout of the battery voltage:
no LED's = less than 9 volts
one red "Recharge" LED = 9 to 12 volts
two red LED's = 12.1 to 12.2 volts
two red and yellow "1/2" LED = 12.3 to 12.4 volts
all 4 LED's (including green "Full" LED) = 12.5 volts and up
The positive battery terminal cable terminator is ring terminal 11/16" across with a 3/8" hole. The negative battery terminal cable terminator is ring terminal 11/16" across with a 5/16" hole.
The positive battery screw terminal is .365" across, suitable for a 3/8" ring/spade terminal. The negative battery screw terminal is .31" across, suitable for a 5/16" ring/spade terminal.
28 of 28 found the following review helpful:
A must-have for inflatable raftAug 03, 2014
By Pierre Burthey
How to give a fair evaluation when you've been using only two weeks ? That's why I will update on a regular basis. Today it's a four stars product. It could have been a five one with those 3 missing items:
1. No notice ! Even a toothbrush comes with a notice. What am I supposing to do with the plastic parts in the bag ?
2. I'm using a Group 24 battery and wish to get some plastic parts to block the battery (I put styrofoam, see my pics)
3. Wires could be longer or more flexibel
The handle is very sturdy, (battery+box= 50.2 lbs), the 12V plug is ideal to inflate our boats and this ensemble will be a perfect spare for our tent trailer.
Be sure I will update this evaluation if something wrong happens.
58 of 65 found the following review helpful:
Great productAug 27, 2009
By L. A. Kane
Very well designed. Fits group size 24 and 27 batteries. Keeps the battery dry with a sturdy plastic box and you safe with a built-in circuit breaker. There's a 12-volt accessory jack built in along with two manual reset circuit breakers, a 15-amp for acccessory plugs and a 60-amp for the trolling motor itself. The screw down's on the front work great, but you need to remove them to recharge the battery with a clamp-type charger, but that's less hassle than removing the battery from the case to recharge. I'm very happy with this purchase.
See all 620 customer reviews on Amazon.com