Computers & Add-Ons
|Home » |
Book Lift Textbook & Large Manual Copy Holder
Designed for e-readers, tablets, planners, large manuals, or reference materials, the Fellowes Booklift Copyholder features two patented adjustable clips to hold pages open at the desired location. The flexible easel design has a non-skid base and offers nine height adjustments to provide a variety of viewing angles. Folds flat for compact storage and portable ease. Holds standard letter size ring binders. Holds up to 10 lbs. at a time.
Ideal for e-readers (Kindle, Kindle Fire), tablets (iPad), planners, large manuals, or reference materials
Two patented adjustable clips hold pages open at desired location
Nine height adjustments for a variety of viewing angles
Easel-style holder with non-skid base folds flat for easy storage
Holds standard letter size ring binders & holds up to 10 lbs. at a time
|Average Customer Rating:
|| based on 156 reviews|
Average Customer Review:
( 156 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
152 of 166 found the following review helpful:
Total rip-offAug 08, 2005
By M. Warren
In the ten minutes since I've had it out of the box two pieces have fallen off. More importantly, It can't handle large manuals as advertised. (The reason I purchased this particular book holder) My 1000 page manual only fits if you happen to only want to read the middle chapter. Based on that I estimate that this is a totally worthless product to anyone needing to go through a manual or training book more than five or six hundred pages. If you don't anticipate needing it for a book that big then just glue the rubber feet on, keep an eye on the page retainers (these are the parts that fell off) and you should be ok. As for me, I'm off to read Amazon's return policy and see if I can get rid of this useless hunk of plastic.
171 of 188 found the following review helpful:
Skip this one, and buy either BOOK BUTLER or ROBERTS BOOK HOLDER insteadJun 01, 2007
By Jeff A. Deskins
From the perspective of one whose only hand suffers from both arthritis and Carpal Tunnel Syndrome, I rate the ROBERTS BOOK HOLDER, the BOOK BUTLER, and the Fellowes Book Lift Copyholder in 4 areas:
1. Ease of putting a book in the holder
2. Ease of turning pages
3. Holder's ability to keep book open
4. Major Strength/weakness
However, I will first describe the ROBERTS BOOK HOLDER, the BOOK BUTLER, and the Fellowes Book Lift Copyholder:
The ROBERTS BOOK HOLDER occupies 7.5 x 14 inches of table space, does not provide any elevation, but does permit placement of pegs at various widths and depths. It is very stable, and cannot tip over. Its pegs are not parallel to the book's pages, and are about 1 inch high.
The BOOK BUTLER occupies about 7 inches of width and about 8 in depth. Its pegs are 3/4 inch high, and the pegs are parallel to the pages, which means there is only a very minor chance of pages slipping past the pegs. This would only happen if the book was very stiff or if it were a hardback whose cover extended much more than 3/16th of an inch below the bottom of the pages. It has springs to hold its pegs snugly against the pages. The BB also elevates the book about 2 inches above the tabletop. Its metal rod may be inserted to hold books at two different angles: 45 or 15 degrees.
The The Fellowes Book Lift Copyholder is 11 5/8 wide and has an adjustable angle that can be varied to 5 or 6 positions. It folds into a flat easily carried sheet of plastic. It has holes to fit it into a 3 ring binder. Its two adjustable clips simply fail to hold anything but comic books open.
1. Ease of putting a book in the holder: ROBERTS BOOK HOLDER: 5/5; BOOK BUTLER 3/5; FELLOWES BOOK LIFT COPYHOLDER 2/5. I had no difficulty inserting a book into the Roberts Book Holder, while I did find it awkward to do so with the BOOK BUTLER. However, even with only one hand and it has both arthritis and Carpal Tunnel Syndrome, I was able to put a 2 1/2 inch thick hardback into the BOOK BUTLER without much difficulty. It is only a matter of figuring out how to do so with only 1 hand. The FELLOWES BOOK LIFT COPYHOLDER simply will not hold anything thicker than a small soft cover book, although putting it in was not too hard.
2. Ease of turning pages: ROBERTS BOOK HOLDER: 3/5; BOOK BUTLER 5/5; FELLOWES BOOK LIFT COPYHOLDER 2/5. While it was easy to turn pages with the Roberts Book Holder in most cases, there was some difficulty when the pegs were tightly pressed against the pegs. Also note that the pages must be lifted above the pegs, and can rip if carelessly handled. Compared to the BOOK BUTLER, this was noticeably inferior. Turning pages with the BOOK BUTLER involved lifting the hinged tab with one finger while turning the page with thumb and index finger. The FELLOWES BOOK LIFT COPYHOLDER's tabs are hinged, and therefore flip easily out of the way for turning pages. However, the pages simply will not stay open.
3. Holder's ability to keep book open: ROBERTS BOOK HOLDER: 3/5; BOOK BUTLER 5/5; FELLOWES BOOK LIFT COPYHOLDER 0/5. As mentioned earlier, the Roberts Book Holder has pegs that are at a slight angle to the pages, which may allow stiff books' pages to slip past the pegs. However, the BOOK BUTLER performed flawlessly. Note that I primarily use soft backs but not standard paperback novel-sized books. Manga books work fine. The FELLOWES BOOK LIFT COPYHOLDER fails almost every time to hold the book open. It would work fine with comic books as long as they are stapled in the middle and very thin.
4. Major strength/weakness: The ROBERTS BOOK HOLDER's major weakness is that its pegs are easily lost. Note that replacement pegs are available: Roberts Book Holder: Book holder replacement pegs - package of 2. People with severe arthritis may have difficulty handling the pegs. A secondary weakness is the fact that the pegs are not parallel to the pages, thus, pages are more likely to slip past the pegs than they are in the BOOK BUTLER. The ROBERTS BOOK HOLDER's pegs being round can roll away if dropped on the floor. However, its stability upon the tabletop is much better than the BOOK BUTLER, whose major weakness is its narrow 7 inch width that may cause it to tip over when holding a wide and heavy book. I just tried a standard college textbook in the BOOK BUTLER. Placing it in open to its table of contents was noticeably more difficult than it would have been in the ROBERTS. With the textbook in the holder, flipping from the table of contents to the index is awkward, mainly because of the transfer of weight from one side to the other, and would require sliding it so that the bulk of the weight remains near the middle. The FELLOWES BOOK LIFT COPYHOLDER's only redeeming feature is that it folds flat, and can be carried in a backpack without being in its box. Its adjustable clips simply flip over with the force of most any book. It is worthless as a book holder. It pales in comparison to either the BOOK BUTLER or the ROBERTS BOOK HOLDER. It is only good for thin magazines stapled in the middle. I had one that I used for a few years, but it simply was not worth the money. Nothing would stay open adequately. My attempts to stiffen the clips were futile.
I have carried the ROBERTS in its box a backpack for about a year, its box is worn but it is still in great shape because it stores flat. However, the BOOK BUTLER does not fold flat, and I would not think it would be appropriate for a backpack crammed full of heavy books, even if it were stored in its box. I have used the FELLOWES BOOK LIFT COPYHOLDER in that same backpack prior to buying the Roberts. There were no problems in carrying it, but since it fails in its purpose, why bother?
Thus, for home, I prefer the BOOK BUTLER; I am keeping the ROBERTS in my backpack; the FELLOWES is in the landfill.
51 of 56 found the following review helpful:
Not suitable for heavy booksOct 11, 2006
This bookstand, despite the description, is not suitable for heavy books. If you put heavy books on this, the stand that props up the whole unit is likely to snap off.
16 of 17 found the following review helpful:
Simply PerfectJun 30, 2008
By Clarke Waldron
I consider myself fortunate to have found this as when I was searching, I did not know that it would be a "copyholder" and not a "bookholder".
This is well-designed. It has several different angle adjustments. It is quite robust. It folds down quickly to be quite flat. Especially appreciated is that the use of the fingers which can hold the pages at the bottom is optional; they can remain folded down. This allows ease in turning pages.
I use it every day to allow reading while I have lunch and I am sure that I am the envy of the other lunch readers as they struggle with reading their books in their hands or flat on the table.
12 of 12 found the following review helpful:
Booklift gets the job done.Aug 07, 2010
A good book stand if you need something portable. I use the book stand regularly with Physics for Scientists and Engineers with Modern Physics, Chapters 1-46 (with CengageNOW 2-Semester, Personal Tutor Printed Access Card), a 1500 page book weighing 7 pounds. The stand has never collapsed and holds pages as tightly or loosely as I need. When studying the early chapters or later chapters in the physics book, I shift the book left or right to center the weight on the stand. The stand is also useful for my cook books and Kindle. However a large book like CRC Handbook of Chemistry and Physics, 91st Edition, at 2600 pages, is too thick for the stand (along with most other book stands).
The only hassle I've had are parts will tend to pop off when folding the stand flat or getting the stand ready to use. Three parts are most prone for coming off, the two page holders in the front and the upper piece along the back supporting the stand. The parts snap back into place and never popped out when actually supporting a book. Only when in the process of putting the stand away or getting it out. The Fellowes Booklift is not a perfect stand, but it gets the job done. If you don't mind popping parts back into place and portability is important for you at a descent price, the Fellowes Booklift is a good way to go.
Very portable being light weight and folding flat.
Will hold ~1500 page text book firmly.
Parts will pop out when folding flat or setting up.
Will not hold ~2600 page books.
** EDIT **
A couple of months ago, shortly after my initial review, I used a Q-tip to apply a very small amount of WD-40 (lubricant)to the joints where pieces kept popping out. Since then I haven't had a single piece pop out of place even with frequent use.
See all 156 customer reviews on Amazon.com